Land Rover Discovery: Liftgate Window Glass (G1805065)
/ Removal and Installation
READ NEXT:
Removal
Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation,
Removal and Installation).
NOTE:
Make sure that this component is installed to the noted
removal position.
Torque: 7 Nm
To
Installation
CAUTION:
Make sure that the mating faces are clean and free of foreign
material.
NOTE:
Install new spacers.
NOTE:
The tailgate is manufactured from aluminium. Make sure that
appropria
REMOVAL
Refer to: Rear Door Trim Panel (501-05, Removal and Installation).
Torque: 1.2 Nm
Torque: 1.2 Nm
INSTALLATION
NOTE:
An audible click is heard when the clips are fully latched
SEE MORE:
To program a remote device to a
previously programmed RF transceiver
memory button:
Press and hold the desired RF
transceiver memory button. After
approximately 20 seconds, the LED
will start to flash slowly.
Follow the instructions described in
step (2) onwards, as described in
PROGRAMMING.
Electrical connector - ECM position sensor 5V supply
Electrical connector - shroud control solenoid 12V supply
Position sensor
Variable coolant pump body
Drive pulley hub
Seal
Shroud
Pump impeller
The variable coolant pump is located on the upper left side of the engine
within a cavity i