Land Rover Discovery: Rear end Sheet Metal Repairs Back Panel Outer (G1770946)
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Rear end Sheet Metal
Repairs Back
Panel Outer (G1770946)
- Rear end Sheet Metal Repairs Back Panel Outer (G1770946) - Removal
- Rear end Sheet Metal Repairs Back Panel Outer (G1770946) - Installation
Rear end Sheet Metal
Repairs Inner
Quarter Panel
Assembly (G1770950)
- InstallationRear end Sheet Metal
Repairs Back
Panel Outer (G1770946)
- Removal
READ NEXT:
Rear end Sheet Metal
Repairs Back
Panel Outer (G1770946)
- Removal
Removal
NOTE:
The back panel outer is installed in conjunction with:
Rear bumper cover
Rear bumper
Rear bumper retaining rail
Rear lamp assembly
Quarter panel lower extension
Loadspace trim pan
Rear end Sheet Metal
Repairs Back
Panel Outer
(G1770946)
- Installation
INSTALLATION
Dress the flanges where necessary.
Offer up the new back panel outer panel and clamp into position.
Check alignment, if correct, proceed to next step, if not, rectify and
recheck bef
SEE MORE:
Steering Column Steering
Wheel (G1775242) / Removal and
Installation
REMOVAL
CAUTION:
Make sure that the road wheels are in the straight ahead position.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential
information is always correct.
Make the SRS system safe.
Refer to: Stand
Rear Drive Halfshafts
Outer Constant
Velocity Joint
Boot (G1791657) / Installation
Installation
CAUTION:
Extreme cleanliness must be exercised when handling these
components.
Clean and inspect the components for deterioration.
CAUTION:
Make sure that a new outer joint boot is to be installed.
Renew Part: Outer constant velocity joint boot kit.
Pack the outer CV joint with the
© 2019-2026 Copyright www.lrdisc.com
