Land Rover Discovery: Rear end Sheet Metal Repairs Inner Quarter Panel Assembly (G1770950)
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Rear end Sheet Metal
Repairs Inner
Quarter Panel
Assembly (G1770950)
- Rear end Sheet Metal Repairs Inner Quarter Panel Assembly (G1770950) - Removal
- Rear end Sheet Metal Repairs Inner Quarter Panel Assembly (G1770950) - Installation
Rear end Sheet Metal
Repairs Inner
Quarter Panel
Upper (G1770949)Rear end Sheet Metal
Repairs Inner
Quarter Panel
Assembly (G1770950)
- Removal
READ NEXT:
Rear end Sheet Metal
Repairs Inner
Quarter Panel
Assembly (G1770950)
- Removal
Removal
NOTE:
The inner quarter panel assembly is installed in conjunction with:
Rear bumper cover
Side panel
Quarter panel
Quarter panel lower extension
Fuel tank
Fuel tank filler pipe
Rocke
Rear end Sheet Metal
Repairs Inner
Quarter Panel
Assembly (G1770950)
- Installation
Installation
Dress the flanges where necessary.
CAUTION:
This step will require the aid of another person as the panel
will be heavy.
Offer up the new inner quarter panel assembly and clamp into
SEE MORE:
Anti-Theft - Active Anti-Theft Alarm Horn with Integral Battery (G1791765)
/ Removal and Installation
SPECIAL TOOL(S)
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Refer to: Fender Splash Shield (501-02 Front End Body Panels,
Removal and Installation).
Special Tool(s): JLR
Rear Suspension Wheel
Knuckle (G1775239) / Removal
SPECIAL TOOL(S)
PART(S)
REMOVAL
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on
the suspension.
Do not allow halfshafts to hang unsupported at one end or joint
damage will occur.
Make sure the halfshaft constant velocity (CV) joints do not over
articulate. Fail
© 2019-2026 Copyright www.lrdisc.com
