Land Rover Discovery: Rear end Sheet Metal Repairs Rear Lamp Panel Outer (G1771163)
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Rear end Sheet Metal
Repairs Rear
Lamp Panel
Outer (G1771163)
- Rear end Sheet Metal Repairs Rear Lamp Panel Outer (G1771163) - Removal
- Rear end sheet metal repairs rear lamp panel outer (G1771163) - Installation
Rear end Sheet Metal
Repairs Rear
Side Member
Closing Panel (G1780740)
/ Removal and InstallationRear end Sheet Metal
Repairs Rear
Lamp Panel
Outer (G1771163) -
Removal
READ NEXT:
Rear end Sheet Metal
Repairs Rear
Lamp Panel
Outer (G1771163) -
Removal
Removal
NOTE:
The rear lamp panel outer is installed in conjunction with:
Rear bumper cover
Rear bumper
Rear lamp assembly
Quarter panel
Quarter panel lower extension
Side panel
Loadspace trim
Rear end sheet metal repairs rear lamp panel outer (G1771163) -
Installation
Installation
Dress the flanges where necessary.
Offer up the new rear lamp panel outer and clamp into position.
Check alignment, if correct, proceed to next step, if not, rectify and
recheck befo
SEE MORE:
Rear Seat (G1817116) / Removal and
Installation
REMOVAL
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
LH illustration shown, RH is similar.
All vehicles
Vehicles without occasional rear seats
Vehicles with o
Towing Points
CAUTION:
The single towing points at the front and rear of the vehicle are
designed for vehicle recovery purposes only and must NOT be used
to tow a trailer or caravan.
The front towing eye is accessible after releasing and removing the towing
eye access panel.
CAUTION:
Make sure that during towi
© 2019-2026 Copyright www.lrdisc.com
