Land Rover Discovery: Rear end Sheet Metal
Repairs Spare
Wheel - Vehicles
Without- 7 Seats (G1770929)
READ NEXT:
Removal
NOTE:
The spare wheel well is installed in conjunction with:
Rear bumper cover
Rear bumper
Rear bumper retaining rail
D-pillar trim panel
Back panel outer
Back panel inner
Exhaust syst
Installation
Dress the flanges where necessary.
Offer up the new spare wheel well and clamp into position. Check
alignment, if correct, proceed to next step, if not, rectify and
recheck before pr
SEE MORE:
Glow plug (4 off)
Glow plug harness
The glow plug system has a glow plug installed in the inlet side of each
cylinder. The glow plugs heat the combustion chambers before and during
cranking, to aid cold starting, and after the engine starts to reduce
emissions and engine noise when idling with
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
CAUTION:
Note the installed position of the component prior to
removal.
Torque: 25 Nm
NOTE:
Do not disassemble further if the component is removed for
access only.
INSTA