Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Rear end Sheet Metal Repairs Spare Wheel - Vehicles Without- 7 Seats (G1770930)

Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General Information / Rear end Sheet Metal Repairs Spare Wheel - Vehicles Without- 7 Seats (G1770930)

next pageRear end Sheet Metal Repairs Spare Wheel - Vehicles Without - 7 Seats (G1770929) - InstallationRear end Sheet Metal Repairs Spare Wheel - Vehicles Without - 7 Seats (G1770930) - Removalnext page

READ NEXT:

 Rear end Sheet Metal Repairs Spare Wheel - Vehicles Without - 7 Seats (G1770930) - Removal

Removal NOTE: The spare wheel well is installed in conjunction with: Rear bumper cover Rear bumper Rear bumper retaining rail D-pillar trim panel Rear folding seats Back panel outer Back pane

 Rear end Sheet Metal Repairs Spare Wheel Well - Vehicles With- 7 seats (G1770930) - Installation

Installation Dress the flanges where necessary. Offer up the new spare wheel well and clamp into position. Check alignment, if correct, proceed to next step, if not, rectify and recheck before pr

 Rear end Sheet Metal Repairs Rear Wheelhouse Outer (G1770944)

SEE MORE:

 Crankshaft Pulley (G1875869) / Removal and Installation

SPECIAL TOOL(S) PART(S) REMOVAL NOTE: Removal steps in this procedure may contain installation details. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, S

 Engine Emission Control - Ingenium i4 2.0l Diesel Diesel Exhaust Fluid Pipe (G1875910) / Removal and Installation

REMOVAL Raise and support the vehicle on a suitable 2 post lift. Refer to: Lifting (100-02 Jacking and Lifting, Description and Operation). Remove the driveshaft. Refer to: Driveshaft - INGENIUM I4 2.0L Diesel, Vehicles With: Active Driveline (205-01 Driveshaft, Removal and Installation). Refer t

© 2019-2026 Copyright www.lrdisc.com