Land Rover Discovery: Rear end Sheet Metal
Repairs Rear
Wheelhouse Outer (G1770944)
READ NEXT:
Removal
NOTE:
The rear wheelhouse outer is installed in conjunction with:
Rear bumper cover
Side panel
Quarter panel
Quarter panel lower extension
Inner quarter panel upper
Fuel tank filler pip
Installation
Dress flanges where necessary.
Remove the bracket from the new rear wheelhouse outer as
indicated.
Drill holes where the metal inert gas (MIG) plug welds are to be
installed
SEE MORE:
REMOVAL
WARNING:
Brake pads must be renewed in axle sets only. Failure to follow this
instruction may result in braking efficiency being impaired.
Connect the diagnostic tool and set the electronic park brake (EPB)
to the maintenance position.
NOTE:
This step is only required if the diagnostic t
Installation
Dress the flanges where necessary.
Detach the upper and lower B-pillar reinforcement spot welds from
the new ring frame as indicated.
Separate the joints and remove the B-pillar reinforcement from the
ring frame as indicated.
Offer up the new B-pillar reinforcement and clamp