Land Rover Discovery: Exterior Trim and Ornamentation
Rear Spoiler (G1791772)
READ NEXT:
Removal
CAUTIONS:
Make sure to protect the paintwork.
Make sure that all openings are sealed. Use new blanking caps.
Refer to: High Mounted Stoplamp (417-01, Removal and
Installation).
CAUTI
Installation
NOTE:
Position cloth to collect fluid spillage.
CAUTION:
Only tighten the bolts finger-tight at this stage.
CAUTION:
Only tighten the nuts finger-tight at this stage.
CAUTION:
M
REMOVAL
CAUTION:
LH illustration shown, RH is similar.
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and s
SEE MORE:
Installation
NOTE:
Make sure that the drilled out spot welds are installed with metal
inert gas (MIG) plug welds in the same quantities.
Using the old suspension top mount for reference prepare the new
suspension top mount in the areas where it is not fully welded and
install the spot welds.
CA
COMPONENT LOCATION - ALL WHEEL DRIVE SYSTEM - VEHICLE SWITH OUT ACTIVE
DRIVELINE
Power Transfer Unit (PTU)
Driveshaft
Active On-Demand coupling
Rear differential
POWER TRANSFER UNIT (PTU) - VEHICLES WITHOUT ACTIVE DRIVELINE
Transmission
Power Transfer Unit (PTU)
OVERVIEW
Vehicles with