Land Rover Discovery: Side Panel Sheet Metal Repairs 'B' Pillar Outer Panel (G1770904)
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Side Panel Sheet
Metal Repairs 'B'
Pillar Outer
Panel (G1770904)
- Side Panel Sheet Metal Repairs 'B' Pillar Outer Panel (G1770904) - Removal
- Side Panel Sheet Metal Repairs 'B' Pillar Outer Panel (G1770904) - Installation
Side Panel Sheet
Metal Repairs B-pillar
Inner
Panel (G1770906) / Removal and
InstallationSide Panel Sheet
Metal Repairs 'B'
Pillar Outer
Panel (G1770904) - Removal
READ NEXT:
Side Panel Sheet
Metal Repairs 'B'
Pillar Outer
Panel (G1770904) - Removal
REMOVAL
NOTE:
In this procedure the B-pillar outer panel is installed in conjunction
with:
Front door
Rear door
Front seat
Rear seat cushion
Front safety belt retractor
Front scuff plate trim p
Side Panel Sheet
Metal Repairs 'B'
Pillar Outer
Panel (G1770904) - Installation
Installation
Dress the flanges where necessary
Using the old B-pillar outer panel for reference measure, mark and
cut the new B-pillar outer panel where the Metal Inert Gas (MIG)
welded butt
SEE MORE:
Engine Emission Control - Ingenium i4 2.0l Diesel Diesel Exhaust Fluid Pipe
(G1875910) / Removal and Installation
REMOVAL
Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting (100-02 Jacking and Lifting, Description and
Operation).
Remove the driveshaft.
Refer to: Driveshaft - INGENIUM I4 2.0L Diesel, Vehicles With:
Active Driveline (205-01 Driveshaft, Removal and Installation).
Refer t
Engine Cooling - Ingenium i4 2.0l Diesel Cooling System Partial Draining and
Vacuum Filling (G1809493) / General Procedures
SPECIAL TOOL(S)
DRAINING
WARNING:
Since injury such as scalding could be caused by escaping steam or
coolant, do not remove the filler cap from the coolant expansion tank
while the system is hot.
CAUTIONS:
The engine cooling system must be maintained with the correct
concentration and type of
© 2019-2026 Copyright www.lrdisc.com
