Land Rover Discovery: Side Panel Sheet Metal Repairs B-pillar Reinforcement (G1770905)
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Side Panel Sheet
Metal Repairs B-pillar
Reinforcement (G1770905)
- Side Panel Sheet Metal Repairs B-pillar Reinforcement (G1770905) - Removal
- Side Panel Sheet Metal Repairs B-pillar Reinforcement (G1770905) - Installation
Side Panel Sheet
Metal Repairs
Rocker Panel (G1770907)
- InstallationSide Panel Sheet
Metal Repairs B-pillar
Reinforcement (G1770905) - Removal
READ NEXT:
Side Panel Sheet
Metal Repairs B-pillar
Reinforcement (G1770905) - Removal
Removal
NOTE:
The B-pillar reinforcement is installed in conjunction with:
Front door
Front fender
Rear door
B-pillar outer panel
Headliner
Rocker panel
NOTE:
The B-pillar reinforcement is det
Side Panel Sheet
Metal Repairs B-pillar
Reinforcement (G1770905) - Installation
Installation
Dress the flanges where necessary.
Detach the upper and lower B-pillar reinforcement spot welds from
the new ring frame as indicated.
Separate the joints and remove the B-pillar
Side Panel Sheet
Metal Repairs B-pillar
Inner
Panel (G1770906) / Removal and
Installation
REMOVAL
NOTE:
The B-pillar inner panel is installed in conjunction with:
Front fender
Front door
Rear door
B-pillar outer panel
Headliner
Rocker panel
Rocker panel and B-pillar inner
B-pillar
SEE MORE:
Power Brake aActuation Brake Booster (G1785125) / Removal and Installation
REMOVAL
CAUTION:
If brake fluid is spilt on the paintwork, the affected area must be
immediately washed down with cold water.
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Infor
Rear end sheet metal repairs rear lamp panel outer (G1771163) -
Installation
Installation
Dress the flanges where necessary.
Offer up the new rear lamp panel outer and clamp into position.
Check alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Drill holes in the rear lamp panel outer where the metal insert gas
(MIG) plug
© 2019-2024 Copyright www.lrdisc.com
